Free Delivery on orders over £499
Over 40 years' experience
Price Match we'll beat any price1
Small cut tile samples - ONLY 99P

LTP Glaze Protector 1L

Product ID: 6925
  • £12.49
  • RRP £16.66
  • You save up to 25 %
Item in Stock   |   Usually dispatched within 24 hours
Loading...
Colour: Clear
Size (ml): 1000ml
Approximate Coverage: 30-40m2 per litre (one coat), depending on substrate perosity   
Suitability: Interior use only, not for wetrooms or shower enclosures though. Retains the 'just washed' look on glazed ceramic, porcelain, unpolished porcelain and vitrified quarry tiles

You can use the LTP Coverage Calculator to confirm how much you will need of this product.

The Technical Data sheet can be found here.

NOTE: Not for use on wetrooms or shower enclosures. Do not over-apply as too many coats may cause unsightly build up and/or reduce the efficiency of the product. Hardens after about an hour but will take a further three days to achieve full hardness and become fully water resistant. Always test first to establish the correct method of application and optimum number of coats before general use. 

Interior use only: Retains the 'just washed' look on glazed ceramic, porcelain, unpolished porcelain and vitrified quarry tiles. Easy to maintain.

Low maintenance film forming sealer. Protects and embellishes the surface. Highly resistant to wear and stains. Facilitates maintenance and cleaning. Leave surfaces with a 'just washed' look. 

Directions for use: For newly installed surfaces, ensure the surface to be treated is completely clean, dry and free of cement and grout stains (see LTP Grout Stain Remover). For existing surfaces, first clean and degrease surfaces with LTP Grimex and rinse well. Leave to dry thoroughly (24 hours). Any retained moisture in the grout joint may cause the LTP Glaze Protector to dry opaque or prevent the seal from reaching full hardness.

Application: Apply using a J cloth or sealant applicator pad. Put the contents into a separate container. Dip the cloth into the solution and wring out. Apply evenly to the surface without rubbing. Apply until an even and thin film is created (average. 3 times). Allow to dry (1 hour). For a glossier finish, further coats should be applied at right angles to the first (max. 6).

Aftercare: Routinely sweep the floor. Use LTP Floorshine to clean and protect treated surfaces. In areas where the seal becomes worn, apply more LTP Glaze Protector. At some stage, complete renovation of the deal may be desired. In this case, use LTP Grimex to strip the iriginal seal before resealing. Avoid using strong detergents to wash surfaces treated with LTP Glaze Protector. 

FREE DELIVERY - orders over £499.00, will take up to 2-3 working days (excluding Scottish Highlands and Lowlands). 

STANDARD DELIVERY - £39.00 for orders under £499.00, will take up to 2-3 working days (excluding Scottish Highlands and Lowlands).

Tiles will be shrink-wrapped on a pallet and delivered to the ground-level edge of your property (curb-side). The driver will NOT be able to assist getting the tiles into your property due to insurance purposes. Orders under 20kg weight will be delivered with a parcel courier.

When ordering tile samples, you will receive a small cut sample either 10cm x 10cm or 15cm x 15cm.

We hope that you will be pleased with the tiles that you have bought from Tiles-Direct. But, if you wish to return any goods to us, it must be returned to us in re-saleable condition, in its full original carton/box and the range is still for sale via our website. The customer will be responsible for organising the return of the goods to our distribution warehouse return centre within 30 days of the delivery date. The refund will be processed within 3-5 working days following our receipt of the re-saleable items.

There will be a restocking charge of 10% of the goods returned.

If the goods are not in a re-saleable condition when they arrive back with us, Tiles-Direct reserve the right to amend the amount of the refund based on the value of re-saleable goods.

If you decide to return an entire order, costs will need to be deducted for the delivery, and the return costs.

Delivery charges vary for the following postcodes and will be delivered between 5-7 working days to the following postcodes: GY, HS, IM, IV41,IV30, IV42, IV44 – 49, IV55, IV56, JE, KA27 – 29, KW1 – 14, KW15 – 17, PA21 – 38, PA20, PA40+, PH9, PH15 – 20, PH32 – 44, PH49, PH50, TR21 – 25, ZE.

NOTE: There will be an extra charge for the following postcodes:

AB, DD, IV, KW, PH, FK, FY, TR, PA, KA, LL, PO, SA, CA, DG, EH, EX, G, LD, ML, PL, SY, TA, TD AND TQ.

Vehicle Size & Access

7.5 TONNE TRUCK

18 TONNE TRUCK

The best way to determine if a lorry can access your home/business address is whether you have a bin vehicle collecting from outside your premises.

Wide enough access to accept large delivery lorries (minimum 2.8m)

No obstacles - free of obstacles that could obstruct delivery (e.g. low hanging tree branches)

No Inclines - the delivery area should be flat, rather than a steep slope

Hard and level surface - hand pallet trucks only operate on hard flat surfaces, not loose ground such as grass or gravel

Turning space - ample room to manoeuvre and position the lorry

You MUST advise if there are any parking or time restrictions at the delivery point.           

General Delivery Information:

From our courier, you will receive a text message on the day of the delivery with an 2-hour approximate delivery window. If there any changes or delays you will receive an update via text.

If you have any doubts regarding the condition of the delivery, please ensure to sign for the goods “UNCHECKED”.

You must be available to accept delivery on the day. Failure to do so will result in paying for a re-delivery charge.

Due to insurance and health and safety regulations, our couriers are unable to transport goods into a customer’s property.

 

For Quotations: quotations@tiles-direct.com

For Breakages: breakages@tiles-direct.com

We accept payments over the internet, by phone, fax and mail. We accept Visa, MasterCard, Diners, JCB and all the major credit cards.

The security of your personal information is important to us. When you enter sensitive information (such as credit card number) on our order forms, we encrypt that information using secure socket layer technology (SSL).
We follow generally accepted industry standards to protect the personal information submitted to us, both during transmission and once we receive it. No method of transmission over the Internet, or method of electronic storage, is 100% secure, however. Therefore, while we strive to use commercially acceptable means to protect your personal information, we cannot guarantee its absolute security.

If you have any questions about security on our Web site, you can send an email to us at info@tiles-direct.com.

 


Site Security

All Tiles-Direct.com employees take your personal information very seriously. All employees must learn and obey our security policies. Access to member personal information is limited to key management personnel and our member services department.

Credit Card Information

Credit Card details are only required during a purchase from our website. The details are collected on Secure Trading' secure site and only used for processing by Secure Trading. We do not see or store your credit card details on our site.

ID [Address] Verification

We use secure trading to verify your credit card billing information, in order to ensure that the user is the person identified on the credit card and to insure against fraud.